Kenwood TM-V71A Dual Band: Installation in Dodge Nitro, Continued Part 3 – Mounting and Assembly

IMG_20121004_120147

IMG_20121005_155938

What I decided to do. The remote control head would be velcro-ed the a ledge on the dash. This ledge is slightly angled so that the display is angled upward for best viewing. I also have it rotated ever so slightly to even further improve the viewing angle.(Figure 5 & 6)

Next, where to mount the body of the radio? What I came up with is under the front passenger seat, towards the back. With the contours in the floor pan and the rear bench seat the way it is, this is really, I think my best option. One day if I feel adventurous I may mount it under that bench, but not today.

IMG_20121005_155925IMG_20120920_172933The radio mounting bracket started life as a small piece of 22 gauge steel I found on the side of the road. 22 gauge, how do I know? The sticker was still on it. This was crudely bent by hand to mostly mate up with the curves and contours of the floor. It mostly does. To attach my bracket in a permanent manner I left enough metal to drill a hole and use a seat bolt to hold it down.(Figure 7, 8 & 9) The pressure of the seat holds it firmly.


Now running the wire out from the radio over to the center console, which can be seen in figure 7 & 8. I then ran it through the center console all the way to the front. Up behind the dash and out where the knee panel meets the speed cluster surround.(figure 5 & 6, at the top)Using the factory Kenwood radio mount as a guide, I drilled 4 holes in the sheet metal. Then I bolted it together.

Basically this is all to my mobile installation. There’s a few extra pictures I’ll share here at the bottom.

I’ll write up my external speaker setup later.

IMG_20121005_192807 IMG_20121005_155947 IMG_20121005_155938

Leave a Reply

Your email address will not be published. Required fields are marked *